Difference between revisions of "NATS4 MySQL Auth"
(No difference)
|
Revision as of 10:14, 22 September 2008
Setting up MySQL Auth
This article applies to mod_auth_mysql 3.0
Biller Member Management
Tell the biller to turn off user management on their end.
.htaccess
For NATS password management you'll have to use a mysql auth method, like Apache's mod_auth_mysql. Below are specific config settings for mod_auth_mysql:
AuthName "Members Only" AuthType Basic AuthGroupFile /dev/null AuthMySQLHost localhost AuthMySQLDB <name of the nats datatbase> AuthMySQLUser <user for the nats database> AuthMySQLPassword <password for the user for the nats database> AuthMySQLUserTable member AuthMySQLNameField username AuthMySQLPasswordField password AuthMySQLPwEncryption none AuthMySQLUserCondition "status=1 AND siteid=X" require valid-user
Replace X in "siteid=X" to the ID number of one of your sites. To use a single member's area for all of your sites, remove "AND siteid=X" from the line. See the Multisite Access article for more options.
To use your old password files in combination with mod_auth_mysql, add the following line to the config on top of the auth mod_auth_mysql lines:
AuthMySQLAuthoritative Off
Notes
If other sites on the server use htaccess for authentication, but aren't using mod_auth_mysql, add the followiong options to the top of their htaccess files:
AuthMySQLEnable Off AuthMySQLAuthoritative Off
Alternate Server Member Management
If your NATS database is not on the same server as your member's area, use the following instructions.
Use the GRANT command to grant the appropriate permissions to the NATS database username at the IP address of each member's area server and change the value of the AuthMySQLHost directive to the IP address of the NATS server. If you don't know how to do this, please request your Host or Server admin to allow the NATS database user to access the database from your members area servers.
Database Copy Errors
The following error, which sometimes occur when you copy your NATS database from one server to another, means you didn't escape the MySQL reserved word, cascade:
ERROR 1064 at line 678: You have an error in your SQL syntax. Check the manual that corresponds to your MySQL server version for the right syntax to use near 'cascade char(16) NOT NULL default '', siteid int(10) unsigned
Escape the word cascade with a high comma (`) in the SQL query. Note: the high comma is also called a back-tic, and on US keyboards, it is usually left of the number 1 key.
